4/23/2007
ELITE SCREENS INFRARED REMOTE CONTROL CODE
1. Spectrum, VMAX2 (Plus), Home2(3) and Tension2(3) Series
The wave shape of sending :
And the difference between “0” and “1”
1
0
3a
a
a
3a
“a” is the wave period of 16 X 38K.
Up: 1111 0000 0001
Stop:1111 0000 0010
Down:1111 0000 0100
2. VMAX (Plus), SilverMax, CineTension Series
2.1: Type U ( VMAX Only)
Frequency：455Khz
UP
：010010000
STOP ：010001000
DOWN : 010000100
2.2 Type G ( VMAX, SilverMAX and CineTension)
MCU Code(IR + RF control code protocol)
Remote
Head code+8 digital address code+8 digital operation code
Head Code = 48 counts (Count Clock=32767time/sec)
Digital "1"=24 counts (Counter clock = 32767tim/sec)
Digital "0"=12Counts (Counter clock = 32767tim/sec)
Low level voltage in between each digi. =24 (Counter clock=32767time/sec)
8 digits address code:
1~5digits mapping code to circuit board , high 3 digits and then 0
8 digits operation code
UP
：0xDD
STOP ：0xCC
DOWN ：0xEE
2.3 Type X ( VMAX Only)
(1) IR Controller is using IC # 2272 and 22262 to send and receive.
Frequency: 38KHZ
UP
：1000
STOP ：0100
DOWN : 0010
3. Home Series
Up ： 0xB1 0x4E 0x90 0x6F
Stop ： 0xB1 0x4E 0x8A 0x75
Down ： 0xB1 0x4E 0xCA 0x35
Elite Screens Inc.
|