180A
280A
1160A
C O M M E R C I A L A U D I O S E R I E S
B
T
B
T
he Crown® 180A, 280A, and 1160A are
high-value amplifiers for commercial and
industrial audio. They provide 4-ohm and
constant-voltage outputs (70V and 100V). The
amps are part of Crown’s Commercial Audio
Series, which also includes mixers and mixer-
amps. These low-cost units provide all necessary
features in a simple building-block format.
T
Features
•
1 or 2 inputs, 1 or 2 amplifier output chan-
nels.
breaker/fuse, and thermal protection; details
The amplifiers vary in their number of inputs,
number of outputs, and power range:
•
•
Ideal for commercial and industrial use
•
Three-Year, No-Fault, Fully Transferable War-
ranty completely protects your investment
and guarantees its specifications
Balanced Phoenix-type line inputs; touch-
proofed screw-terminal speaker outputs
• 180A has 1 input and one 80W power amplifier
for single-zone systems.
•
Advanced protection system includes output
current limiting, DC protection, circuit
• 280A has 2 inputs and dual 80W power ampli-
fiers for two-zone systems.
• 1160A has 1 input and one 160W power ampli-
fier for single-zone systems.
Operating Temperature/Humidity: 0° C to 40° C
at 95% relative humidity (non-condensing).
Some applications include schools, hospitals,
factories, restaurant/retail, houses of worship,
fitness facilities, A/V boardrooms, prisons, and
small offices. Typical uses are paging, background
music, security and evacuation instructions.
*1 kHz
Power
Storage Temperature: –20° C to 85° C.
180A
Minimum guaranteed power
Front Panel Controls and Indicators
into 4 ohms or 70V/100V output
The sound system can be upgraded as a facility
expands. For example, you can add more mixers
for more inputs, or add more power amps (or
mixer-amps) to handle more zones.
80W
Power Switch: Pushbutton on-off switch. The
power switch does not affect the 24V DC auxiliary
power input.
*1 kHz Power: refers to maximum power in watts at
1 kHz with 0.5% THD.
Power Indicator: Blue LED indicates power on.
Output Signal Presence Indicator: Green LED,
one for each output channel, illuminates when
output signal level exceeds 100 mV (45 dB below
full power) from the 4-ohm tap.
Specifications
Performance
Frequency Reponse (at 1 watt from 4-ohm tap):
70 Hz to 19 kHz +/- 1 dB.
Clip Indicators: Red LED, one per output channel.
Illuminates at threshold of audible distortion.
Frequency Response (at line out): 20 Hz to 20
kHz +/- 1 dB.
Master Volume Controls: One per output channel.
Detented potentiometer with knob.
*
1 kHz
Power Bandwidth (at 4-ohm tap, 2 dB below
maxium 1 kHz power): 50 Hz to 20 kHz with
< 0.5% THD
280A
Power
Tone Controls: Bass and Treble non-detented
potentiometers on each channel. Bass 10 dB at
100 Hz, Treble 10 dB at 10 kHz.
Minimum guaranteed power
per channel into 4 ohms or
70V/100V output
Signal to Noise Ratio (ref. to rated power, master
volume at minimum): 85 dB.
80W
Back Panel Controls and Connectors
DC Output Offset: < 5 mV.
*1 kHz Power: refers to maximum power in watts at
1 kHz with 0.5% THD.
Reset Switch: Resets the circuit breaker that
protects the power supply. 220/230/240V units
have a fuse instead.
THD: Less than 0.5% at rated power at 1 kHz.
Input Sensitivity (for full output at maximum
gain): 800 mV.
AC Power Inlet: Detachable IEC.
Input Impedance (nominal): 100 kilohms.
Auxiliary Power Input: 2-position terminal strip
for 24 VDC ( 10%) backup power. Accepts up to
14 AWG terminal forks.
Minimum Load Impedance:
100V output: 160 ohms.
70V output: 80 ohms.
Amplifier Outputs Connectors: One per channel,
4-position terminal strip with COM (Common), 4
ohms, 70V and 100V terminals. Accepts up to 10
AWG terminal forks. Non-touch cover included.
4-ohm output: 4/8 ohms.
*1 kHz
Power
Crosstalk (all controls at “10”): –70 dB at 1kHz.
Line Output Level (nominal): 1V into 10 kilohms.
1160A
Minimum guaranteed power
Output VCA Connector: One for every two chan-
nels, 4-pin Phoenix-type connector for two VCA
control lines of +10 VDC and ground. Compatible
with Crown 1-VCAP and 4-VCAP modules.
AC Line Voltages Available:
100V 50/60 Hz
120V 60 Hz
220V 50/60 Hz
230V 50/60 Hz
into 4 ohms or 70V/100V output
160W
*1 kHz Power: refers to maximum power in watts at
1 kHz with 0.5% THD.
240V 50/60 Hz
|
Compaq Network Router MTEK6000 User Manual
Cooper Lighting Indoor Furnishings VRX Series User Manual
Cooper Lighting Landscape Lighting LXD70SR2334 User Manual
Craftsman Lawn Aerator 48624218 User Manual
DVS Blower 99000153 User Manual
Edimax Technology Security Camera MD 111E User Manual
Electro Voice Marine Radio electrovoice User Manual
Franklin Industries LLC Refrigerator FCR36OD User Manual
Frigidaire Washer FAFS4272LA User Manual
GE Monogram Oven ZGU36N6DSS User Manual